Change the line in frame Nylor.
Required tools
1. Fishing line 0,50mm
2. Oblique cutter
3. Hook
4. Nose pliers
Process
- First with the help of hook discard the old line carefully to avoid hurting the color of the frame and clean point that holes are visible.
- Cut a piece of string, sufficiently longer than necessary, using the lateral cutter and such that the tip of the line is tapered.
- We pass the pointed end of the line or in the temporal or nasal holes, preferably where it is difficult to access, as long the line helps us to handle. The transition is first made on the internal side of the lower hole and then from the outer side of the top hole.
- Using nose pliers push the piece of string left over to put into the inside groove of the frame to the point that meets the edge of the upper string of nylor with no headspace. Having placed the line on one side, now go on easily.
- We adjust roughly the lens to the frame and pass the line through the lens groove until we meet the holes on the opposite side.
- There we cut the line exactly at the point between the two holes. In this simple way the size of the line is always right !!!
- Having now the right size, remove the lens and pass the line into the holes with the help of pliers as now operated by hand is more difficult because of the short length.
- Allow 2-3 millimeters to abound and as before pushing the surplus in the frame groove.
- The frame is now ready to welcome the torch.
If the line is loose remove the lens and pass applied over the frame for three seconds from the heater.
Try it .....
